I need a fusion 360 professional designer to make a co2 dragster

Please make me a unique but aerodynamic design co2 dragster car that follows the design specifications in autodesk fusion 360. PRODUCTION SPECIFICATIONS (a document with all these are attached below) MIN MAX Finished mm / g Dragster Body A. Dragster body length 200 mm 305 mm B. Dragster body height at rear with wheels 75 mm C. Dragster body mass / weight with wheels 45 g 170 g D/r. Dragster body width at axles – front & back (Rail Type) all wheels are outside the body 35mm - 42mm external measurement. 35 mm 42 mm D/s. Dragster body width at axles – front & back (Shell Type) all wheels are inside the body 35mm - 42mm internal measurement with a minimum 3mm wall thickness each side. 35 mm 42 mm E. Dragster Body width (including wheels) 90 mm Axles / Axle Holes / Wheelbase F. Number of axles 2 2 G. Bottom of axle hole above bottom of dragster 5 mm 10 mm H. Rear axle hole from rear of dragster 9 mm 100 mm I. Wheelbase 105 mm 270 mm Spacers / Washers / Clips J. Spacer washers 8 K. Axle clips or similar 8 Power Plant (CO 2 Cartridge Hole) L. Power plant: depth of hole 50 mm 52 mm M. Power plant: housing thickness (around entire housing) 3 mm N. Power plant: housing (diameter) Please use a Forstner bit for best results. 18.80 mm 3/4" O. Power plant: lowest point of chamber diameter to race surface with wheels 26 mm 36 mm Screw Eyes P. Screw eye or eyelet inside diameter 4 mm 8 mm Q. Screw eyes (2) distance apart at farthest point 155 mm 270 mm Wheels R. Wheels: front diameter 32 mm 37 mm S. Wheels: front width at surface contact point 2 mm 5 mm T. Wheels: rear diameter 30 mm 40 mm U. Wheels: rear at surface contact point 15 mm 18 mm OUTLAW CLASS PRODUCTION SPECIFICATIONS MIN MAX PASSED Dragster Body A. Dragster body length 305 mm B. Dragster body mass / weight with wheels 45 g C. Power plant: depth of hole 50 mm 52 mm D. Power plant: housing thickness (around entire housing) 3 mm E. Power plant: housing (diameter) Please use a Forstner bit for best results. 18.80 mm 3/4" F. Power plant: lowest point of chamber diameter to race surface with wheels 26 mm 36 mm G. Screw eye or eyelet inside diameter 4 mm