2-layer PCB board design with Eagle 7.6 and Altium Designer 17 ™

Need a 2-layer PCB board design routed and checked with Altium Designer 17 ™. Scope of work: • Use provided Eagle 7.6 schematic, PCB board design, and Altium Designer 17 ™ design files to create a final production-ready Altium Designer 17 ™ PCB design. • Route all nets and check work. Make sure the SMD and TH parts chosen will work, if not, then suggest a fix. • Make Altium Designer 17 ™ schematic from the Eagle 7.6 schematic provided and populate with symbols, footprint information, and BOM information. • Use standard electrical conventions in the schematics to make them more readable Files Provided • Eagle 7.6 schematic • Build of Materials • Eagle 7.6 PCB board design • Altium Designer 17 ™ design Micro-controller used: ATSAMD21G18A-MU PCB Specs: Manufacturer: [login to view URL] Layers: 2 Size: 72mm by 100mm Thickness: cheapest Color: Green preferred (cheaper better) Silkscreen: Top only (cheaper better) Order size: 10 PCB boards Intended Purpose: an open source I/O board based on the Arduino zero and raspberry pi zero W. No profits are being made from this project. Outputs: 6 channels 24VAC, 1 channel low voltage relay, 20K ohm Honeywell thermostat analog curve Each 24VAC channel must be able to support a 3 to 10 watt load Inputs: 6 channels 24VAC, 2 channels 3.3V 10K ohm thermistor Input channels are from any off the shelf 24VAC thermostat