Look over schematic and PCB design
$15-25 USD / hour
I've hit an impasse. I need you to look over my schematic and PCB and find where I've gone wrong (And correct any mistakes I've made). I've used a Teensy 3.2 for my base design and have decided to use a programing jig so I can pull the MKL02 chip to save space on the main board. The issue is, my arduino IDE does not recognize the board when I have it on the Jig. Receives power, but that's it.
Project ID: #15166628
About the project
20 freelancers are bidding on average $22/hour for this job
Dear Sir, If you are looking for an highly skilled hardware engineer, I believe that I am the one who you're looking for. I am also an experienced PCB designer who has over 16 years design experience on complex PCB More
Hi I am an expert electronics engineer with more than 8 years of experience in circuit design , PCB and schematics design too. Please share the further details of the project I am waiting for your reply to start More
Hi, I am a post graduate power electronics engineer and having very good industrial experience of 8+ years in R&D and project development. I am excellent welding power supplies design, high frequency transformers desi More
I have 9 years working experience in schematic and pcb layout design. Fluent in Mentor Expedition, Cadence Allegro, Mentor PADS, Altium Designer pcb layout tools. Experience in creating footprints library, pcb layout, More
hello sir i have a good experience in circuit and pcb design. i can help you with finding the issue on your design. regards.
Hello, I can help you by having a look over your design. I have 8 years experience in PCB design. I have work on 12 layers PCBs and with chips like GPS, GSM, USB, DDRAM and others What software did you use to More
Hi, Please share your project files and task expected from us, so we can give you correct timeline and budget. About us: Micro-controllers we have worked on PIC, STM32, PSOC and AVR. Development kits and instr More
Hello. It is better review design before telling anything. There is could be schematic or PCB design mistakes.
the per hour rate will be more less. please PM me. i am from Shenzhen, China i can help you to make your project for working prototype
I have experience with Teensy and Arduino IDE and may be I can replicate your situation. I have to go through the schematics. Please send them.
Hi, I have great experience in design and development of hardware/software using ARM based microcontrollers and fault finding and would love to work on this project. regards, Ali Khurram
Hay, I suppose you know what bootloader is. So I think first of all make sure that this MKL02 have bootloader. If it is not with the bootloader then you must have one with bootloader programmed on it. IF there is a b More