RajEmbeddedIoT Profile

EXPLORE

5.0

(3 reviews)

You're now following

Error following user.

This user does not allow users to follow them.

You are already following this user.

Your membership plan only allows 0 follows. Upgrade here.

Successfully unfollowed

Error unfollowing user.

You have successfully recommended

Error recommending user.

Something went wrong. Please refresh the page and try again.

Email successfully verified.

$20 USD / hour

hubbali,

india

$20 USD / hour

It's currently 2:51 PM here

Joined July 30, 2018

1 Recommendation

RajEmbeddedIoT

@RajEmbeddedIoT

5.0

(3 reviews)

3.2

100%

$20 USD / hour

hubbali,

india

$20 USD / hour

100%

Jobs Completed

100%

On Budget

18%

On Time

N/A

Repeat Hire Rate

Embedded engineer with 10 years experience

Experienced embedded software developer for 10 years. Worked for Automotive & consumer electronics. Also worked in few startups as a freelance developer, helping in prototyping ideas & taking them from prototype to product development. Hands on experience on 1) STM32, ATSAMDx, ARM Cortex M family, Atmel(AVR), Raspberryi PI, Beaglebone, ESP8266, ESP32, MSP430, Arduino 2) FREERTOS, embedded Linux, Yocto, Device drivers, FAT-FS, AUTOSAR, GSM(SIMCOM modules, Quectel modules), MQTT 3) SPI, I2C, UART, CAN, SDIO 4) Expert in board bringup, converting Arduino based design to MVP Working at Automotive components supplier has taught me the importance of quality, reliable & safe programming practices & startups help me gain expertise to develop prototypes & products with given resources & build a story around it for investor demos.

See all C Programmers in India

Contact RajEmbeddedIoT about your job

Portfolio

9079377

This project was done to a client who wanted to add 2 nodes to an existing CAN bus.
1st node was a small STM32 based MCU, running baremetal code, to which a motor was connected.
2nd node was a SBC running linux. The processor was based on TI's AM335x which is same as the one present on beaglebone.

I developed a simple CAN bus, tested the SW implementation and delivered the code base

CAN project: 2 MCU and 1 beaglebone black

9079377

CAN project: 2 MCU and 1 beaglebone black

Reviews

Changes saved

Showing 1 - 3 out of 3 reviews

Filter reviews by:

5.0

₹5,000.00 INR

Fix my C program - using RPI for GPIO programming on Raspberry Pi 4

Raj knows his work very well. He solved the problem with precision.

Aditya J.

@aditya500

•

2 years ago

5.0

₹1,000.00 INR

Need assistance in Arduino bootloader for SAMD21 microcontroller

I am very pleased with my experience with Mr. Raj. He was very understanding of my requirements and completed the work at the quickest. I am very delighted with his genuine and sincere approach and would very much work again in future projects with Mr. Raj.